• This item works with: Associated Mini MGT 3.0 RTR, MTA4, Monster GT, Monster GT 4.6, RC-10 B4.x, RC-10 original aluminum chassis, RC-10 T4.x, RC-10GT2, RC-12R5.x, RC-18 RC18R RC18B RC18T 4WD Truck, Buggy, RC-18T2, RC-8 buggy, RC-8 Truck, RC-8e RC8.1e RC-8.2e, RC-8e Truck electric, SC-10 2WD, SC-10 4x4, SC-18, SC-8 Short Course 8, TC-3 Electric Sedan, TC-3 Nitro Sedan; Axial SCX-10 Scale Truck, Wraith 4WD Rock Racer RTR, XR10 Crawler; Durango DESC410R 1:10 Electric 4WD Short Course 

FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE™ can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE™ should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE™. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light weight finish. If room temperature is below 70 degrees F use a heat gun on the surface several times for the next 2 hours. When dry, lightly sand, then fill surface with a low weight spakeling compound, scrapping off excess with a playing card. Sand to a smooth finish ready for primer. For heavy weight fiberglass, apply the epoxy before and after laying down the cloth. FINISH-CURE™ is best mixed in a disposable cup.